Atag WO3011AA Uživatelský manuál stáhnout pdf (Strana 12)

12

Caution: In order to avoid a hazard this

appliance must be installed according to

these instructions for installation

The hob unit can be mounted in any

type of kitchen with a table surface

whose thickness is between 28 mm and

40 mm.

Headroom

The distance to any shelves or tops of a

cabinet under the hob is to be at least 55

mm.

Fixing

Screw the fixing brackets out to such an

extent that they can be turned in under

the table top. Tighten the brackets on to

the table top with an ordinary

screwdriver.

Cut-out measurements

One rectangular hole is sawn out for the

hob combination chosen.

The depth of the cut-out for any unit is:

490 mm

Length of hole = sum of all units`

externally measured length, less 20 mm.

Mounting of Reinforcement

Beams

A reinforcement Beam, with supporting

flanges at each end, is included with

each two-burner unit. For unit

combinations, a reinforcement beam

must be used between each unit.

MIN 55

Mounting

Minimum distance

to wall:

150 mm

Minimum distance to

wall (non flammable

material): 50 mm

Reinforcement

beams

13

It is not necessary to attach the

reinforcement beam to the work top

surface, as it is held in place by a

specially designed moulding, which is

incorporated in the hob units flanges.

The units externally measured

length

290 mm:

Two-zone ceramic-top electric hob

Two-burner gas hob

Grill

Fryer

Wok

Installation of a single unit

When mounting a single unit, be it a

half-or full size unit, in a

worktopsurface which is thicker than

30 mm, it is necessary to make a

special notch in both sides of the cut-

out hole, as shown in the adjacent

drawing.

The purpose of these notches is to

create space for the electrical cables.

4228

1 2 ... 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře